Law of Variable Proportion

By Harpreet CSE

Introduction

 The law of variable proportions states that as the quantity of one factor is increased, keeping the other factors fixed, the marginal product of that factor will eventually decline. This means that upto the use of a certain amount of variable factor, marginal product of the factor may increase and after a certain stage it starts diminishing. When the variable factor becomes relatively abundant, the marginal product may become negative.

Assumptions: The law of variable proportions holds good under the following conditions:

1.      Constant State of Technology: First, the state of technology is assumed to be given and unchanged. If there is improvement in the technology, then the marginal product may rise instead of diminishing.

2.      Fixed Amount of Other Factors: Secondly, there must be some inputs whose quantity is kept fixed. It is only in this way that we can alter the factor proportions and know its effects on output. The law does not apply if all factors are proportionately varied.

3.      Possibility of Varying the Factor proportions: Thirdly, the law is based upon the possibility of varying the proportions in which the various factors can be combined to produce a product. The law does not apply if the factors must be used in fixed proportions to yield a product.

Illustration of the Law: The law of variable proportion is illustrated in the following table and figure. Suppose there is a given amount of land in which more and more labour (variable factor) is used to produce wheat.

It can be seen from the table that upto the use of 3 units of labour, total product increases at an increasing rate and beyond the third unit total product increases at a diminishing rate. This fact is shown by the marginal product which  is the addition made to Total Product as a result of increasing the variable factor i.e. labour.

Units of Labour	Total Product	Marginal Product	Average Product
1	2	2	2
2	6	4	3
3	12	6	4
4	16	4	4
5	18	2	3.6
6	18	0	3
7	14	-4	2
8	8	-6	1

It can be seen from the table that the marginal product of labour initially rises and beyond the use of  three units of labour, it starts diminishing. The use of six units of labour does not add anything to the total production of wheat. Hence, the marginal product of labour has fallen to zero. Beyond the use of six units of labour, total product diminishes and therefore marginal product of labour becomes negative. Regarding the average product of labour, it rises up to the use of third unit of labour and beyond that it is falling throughout. 

Three Stages of the Law of Variable Proportions: -

1.      Stage of increasing returns.

2.      Stage of diminishing returns.

3.      Stage of negative returns.

These stages are illustrated in the following figure where labour is measured on the X-axis and output on the Y-axis.

Stage 1. Stage of Increasing Returns: In this stage, total product increases at an increasing rate up to a point. This is because the efficiency of the fixed factors increases as additional units of the variable factors are added to it. In the figure, from the origin to the point F, slope of the total product curve TP is increasing i.e. the curve TP is concave upwards upto the point F, which means that the marginal product MP of labour rises. The point F where the total product stops increasing at an increasing rate and starts increasing at a diminishing rate is called the point of inflection. Corresponding vertically to this point of inflection marginal product of labour is maximum, after which it diminishes. This stage is called the stage of increasing returns because the average product of the variable factor increases throughout this stage. This stage ends at the point where the average product curve reaches its highest point.

Stage 2. Stage of Diminishing Returns: In this stage, total product continues to increase but at a diminishing rate until it reaches its maximum point H where the second stage ends. In this stage both the marginal product and average product of labour are diminishing but are positive. This is because the fixed factor becomes inadequate relative to the quantity of the variable factor. At the end of the second stage, i.e., at point M marginal product of labour is zero which corresponds to the maximum point H of the total product curve TP. This stage is important because the firm will seek to produce in this range.

Stage 3. Stage of Negative Returns: In stage 3, total product declines and therefore the TP curve slopes downward. As a result, marginal product of labour is negative and the MP curve falls below the X-axis. In this stage the variable factor (labour) is too much relative to the fixed factor.

Importance and Applicability of the Law of Variable Proportion:

The Law of Variable Proportion has universal applicability in any branch of production. It forms the basis of a number of doctrines in economics. The Malthusian theory of population stems from the fact that food supply does not increase faster than the growth in population because of the operation of the law of diminishing returns in agriculture.

Ricardo also based his theory of rent on this principle. According to him rent arises because the operation of the law of diminishing return forces the application of additional doses of labour and capital on a piece of land. Similarly the law of diminishing marginal utility and that of diminishing marginal physical productivity in the theory of distribution are also based on this theory.

The law is of fundamental importance for understanding the problems of underdeveloped countries. In such agricultural economies the pressure of population on land increases with the increase in population. This leads to declining or even zero or negative marginal productivity of workers. This explains the operation of the law of diminishing returns in LDCs in its intensive form. Ragnar Nurkse have suggested ways to make use of these disguisedly unemployed labour by withdrawing them and putting them in those occupations where the marginal productivity is positive.